ASROCK 870 Extreme3 Mode D'emploi page 19

2.5.2 Driver Installation and Setup 2.5.2 Driver Installation and Setup 2.5.2 Driver Installation and Setup 2.5.2 Driver Installation and Setup 2.5.2 Driver Installation and Setup
Step 1. Power on your computer and boot into OS.
TM
Step 2. Remove the ATI
The Catalyst Uninstaller is an optional download. We recommend using this
utility to uninstall any previously installed Catalyst drivers prior to installation.
Please check AMD website for ATI
Step 3. Install the required drivers to your system.
For Windows ® XP OS:
TM
A. ATI recommends Windows
installed (If you have Windows
in your system, there is no need to download it again):
http://www.microsoft.com/windowsxp/sp2/default.mspx
B. You must have Microsoft .NET Framework installed prior to
downloading and installing the CATALYST Control Center. Please
check Microsoft website for details.
®
For Windows 7 / Vista
Install the CATALYST Control Center. Please check AMD website for details.
Step 4. Restart your computer.
Step 5. Install the VGA card drivers to your system, and restart your computer.
Then you will find "ATI Catalyst Control Center" on your Windows
ATI Catalyst Control Center
Step 6. Double-click "ATI Catalyst Control Center". Click "View", select
"CrossFireX TM ", and then check the item "Enable CrossFireX
GPUs" or "4 GPUs" and click "Apply".
ASRock
driver if you have any VGA driver installed in your system.
TM driver updates.
®
XP Service Pack 2 or higher to be
®
XP Service Pack 2 or higher installed
TM
OS:
870 Extreme3 Motherboard
®
taskbar.
TM ". Select "2
1 9 1 9 1 9
1 9 1 9