Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
1.
Cutting bar
2.
Guard
3.
Front grip with safety switch
4.
Shaft handgrip
5.
Fastening clips
6.
Battery pack
7.
On/off switch
8.
Blade guard
9.
Charger
10. Red LED
11. Green LED
ASSEMBLY
For Your Safety
Warning: Switch off and
adjusting or cleaning.
For Your Safety
Warning: Switch off and remove battery
from machine before adjusting or cleaning.
The blades continue to move for a fraction
of a second after the hedgecutter is switched off.
Do not touch the moving blades.
Battery Charging
_
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
Do not use other battery chargers. The supplied
battery charger is designed for the Lithium-Ion
battery in your garden product.
The battery is equipped with temperature mon-
itoring that allows charging only in the tempera-
ture range between 0 °C and 45 °C. In this man-
ner, a high battery service life is achieved.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
remove battery
from machine before
Installing or removing battery
cartridge
CAUTION:
Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge. Failure to
hold the tool and the battery cartridge firmly may
cause them to slip off your hands and result in
damage to the tool and battery cartridge and a
personal injury.
• Always switch off the tool before installing or
removing
the battery cartridge.
Press release of the battery and remove the battery
from the unit by pulling
NOTE:
• Do not use force when installing the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Removing the Battery
Red LED = charging
Green LED = battery charge
OPERATION
Initial Operation
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
For your safety, this tool is equipped with a dual
switching system. To turn on the tool, press the
lock-off button and triggers A and B.
Release either one of the two pressed triggers to
turn off. The sequence of switching is unimportant
as the tool only starts when both switches are
activated.
Switching On
1. Press and hold the On/Off switch on the
rear handle.
2. Then press the front On/Off switch
Switching Off
Release the front or rear On/Off switch.
24
Publicité
Table des Matières
