Mitsubishi Electric PAC-WF010-E Manuel D'installation page 3

(Improper handling may have consequences, including injury or damage to house.)
■ To prevent damage from static electricity,
touch a nearby metal body to discharge static
electricity from yourself before touching the
Wi-Fi interface.
Static electricity from the human body may
damage the Wi-Fi interface unit.
■ Do not install the Wi-Fi interface in a place
with much steam, such as bathroom.
Avoid places where water is splashed or where
condensation forms on walls. Installing in such
places can cause electric shock or breakdown.
■ Do not install the Wi-Fi interface in places
with direct sunlight or where the ambient
temperature is 40ºC or more or is 0ºC or less.
Direct sunlight and high or low temperature
environments may cause the Wi-Fi interface to
deform or breakdown.
■ Please ensure that the access point supports
both WPS connection and the WPA2-AES
encryption setting before commencement of the
installation of the PAC-WF010-E.
■ The end user should read and accept the terms
and conditions of the Wi-Fi service before
commencement of the installation of PAC-
WF010-E.
■ To complete connection of the PAC-WF010-E to
the Wi-Fi service physical access to the access
point may be required.
Mitsubishi Electric's Wi-Fi interface is designed for communication to Mitsubishi Electric's MELCloud
Wi-Fi service.
Third party Wi-Fi interface cannot connect to MELCloud.
Mitsubishi Electric is not responsible for any (i) underperformance of a system or any product;
(ii) system or product fault; or (iii) loss or damage to any system or product; which is caused by or
arises from connection to and/or use of any third party Wi-Fi interface or any third party Wi-Fi service
with Mitsubishi Electric equipment.
For the latest information regarding MELCloud from Mitsubishi Electric Corporation, please visit
www.MELCloud.com.
Caution
■Do not use in special environments.
Use in places with much oil (including machine
oil), steam, or sulfuric gas may lead to severe
decrease in functionality and damage to parts.
■ Turn off power supply of connected
equipment when performing construction or
wiring work.
Failure to turn off the power supply to the
connected equipment may lead to malfunction or
breakdown of the Wi-Fi interface or connected
equipment.
■ The connecting cable must not touch copper
pipings directly.
Note
■ The PAC-WF010-E will not commence
transmission of any operational data from the
system until the end user registers and accepts
the terms and conditions of the Wi-Fi service.
■ The PAC-WF010-E should not be installed and
connected to any Mitsubishi Electric system
which is to provide application critical cooling or
heating.
■ Please write down about the model information
and more on the last page"Setting information",
When you install the PAC-WF010-E.
■ This equipment should be installed and operated
with a minimum distance of 10cm between the
device and the user or bystanders.