Ring Automotive RAC640 Instructions D'utilisation page 3

Control lay out
1) Compressor / Inflator selection power switch
2) + push & hold button to increase preset pressure
3) M push to select pressure measurement. PSI, KPA or BAR
4) – push & hold to decrease preset pressure
5) LED light switch on/off button
6) Inflation outlet +
7) Deflation outlet -
8) Air hose & valve connector with deflation button
7
6
5
11
9
12
Compressor Operation – preset the automatic pressure gauge:-
Vehicle tyre inflation
Fig 1 Fig 2
Remove the Velcro retaining strap and uncoil all of the power cable on the rear of the
compressor, ensuring all the cable is unwound. Insert the 12v DC plug into the 12v
socket. (Fig 1)
Remove the dust cap from the tyre valve and store in a safe place.
Carefully pull out the air hose from the rear of the compressor. Screw the valve
connector clockwise onto the tyre valve. Ensure the valve is correctly connected but do
not over tighten. (Fig 2)
Press M button to select pressure gauge measurement from Bar, KPA, Psi (Fig 3)
Caution
: Only inflate product to the manufacturer's specifications. Vehicle
tyre pressures can generally be found in the handbook, on the door pillar or on
the inside of the fuel filler cap.
The LCD display will show the current tyre pressure.
Hold + or – button for approx 5 seconds until LCD display flashes (Fig 3). Set the
required pressure using the + or – buttons then wait 2-3 seconds. The LCD will display
the current pressure value to which the tyre will be inflated.
Turn the yellow power switch anti-clockwise to the tyre symbol for the compressor to
start (Fig 4). When the pressure gauge reaches the required value the compressor will
automatically switch off and the LCD display will show "OFF".
If accidentally over inflated, deflate the tyre by depressing the deflation button on the air
hose (Fig 5). To check the pressure release the button, wait 2 seconds then check the
digital display for pressure reading. Repeat until the desired pressure is reached.
9) Fused 12v DC plug
10) Inflator / deflator pipe
11) LED light
12) 7 x Valve adapters
13) Air hose storage
14) 12v DC power cable storage
15) Items 10 & 12 are stored in the
compartment in underneath the compressor
4
3
14
2
1
10
8
Fig 3 Fig 4
Autogoods "130"
13
15
Fig 5