Important - Star Pool AR1550 Manuel D'instructions

1. Security
Basic Councils for safety and prevention damages.
ATTENTION: read attentivly the instructions. To assure the safety of the foreign persons
and the ideal functioning of the equipment, it is indispensable that, before realizing the
assembly and the start up, both the installer and the user read the instructions.
In everything relating to the electrical installation, you must follow the regulation NF C15-
100 / IN 60-335-2-41 which refers to " the construction of electrical facilities, so much in
swimming pools covered like in swimming pools outdoors ", or the analogous in force
regulation in every zone or country.
"All filtrations follow the installation norm C 15-100 that specifies that any electrical device
located to less than 3'5m from the swimming pool and freely accessible must be fed by
very low tension 12V. Any device fed in 220V must be located at least 3'5m from the edge
of the swimming pool. Please, ask the manufacturer for any modification of one o more
elements of this system"
• Electrical installation must be done by professional personnel qualified in electrical
facilities.
• The height of the sand must not exceed 2/3 of the height of the filter.
• Do not have the device turned on while using the swimmin pool.
• Do not run the device if it is not well primed.
• Never touch the filter while running with humid body or humid hands.
• When the filter valve is manipulated, always DISCONNECT the pump.
• Make sure that the soil is dry before touching the electrical equipment.
• Do not place the electrical equipment where it could be wetted; it can cause
electrocution.
• Do not allow any person to rest or to sit down on the device.
• · If the flexible cable is damaged, it must be replaced. Read the instructions for its
replacement. For any doubts, call your a technical service.
IMPORTANT: The manual that you have in your hands contains fundamental
information about safety measures to adopt at the moment of the installation and
maintenance. It is indispensable that both the installer and the user read the
instructions before going on to the assembly.
User must keep the manual and safety etiquettes in good conditions for the successive
use.
Carry out the installation in agreement with the safety indications for swimming pools
and with the particular indications of the pump and selector valve.
Even if the lid is designed to support the weight of an adult, it is not allowed to children
or adults to walk or to jump on the equipment, our to develop activities that endure
some risk for the equipment.
Clean always with a moist cloth with a solution of neutral soap. Do not use products
that contains solvents or acids.
To use only the equipment for water filtering of domestic swimming pools or small
reservoirs.
During periods of not utilization, we recommend to empty the circuit.
ENGLISH