Normal Mode; Learning Mode - Polk Audio SurroundBAR SDA Manuel D'utilisation

1
EASY HOOKUPS AND SIMPLE CONTROLS
1 LED—A light that shines green, orange or red
to indicate operating status.
2 Power—Turns on the SurroundBar
it in standby mode.
3 Mute—Mutes the sound coming from the SurroundBar
SDA and wireless subwoofer.
4 Volume Up and Down—Adjusts the volume
of the SurroundBar SDA and Wireless Subwoofer.
5 Remote—Puts the SurroundBar SDA into "learning mode"
so you can program it to respond to commands from your
remote control.
6 Channel ID Switch—Selects the "channel" for the wireless
subwoofer signal. Don't forget to select the same
"channel" on the Wireless Subwoofer itself.
7 Gain Level Switch—Adjusts the input sensitivity
of the SurroundBar SDA (see page 9).
8 Audio Inputs—Where you connect your TV (or other source)
to the SurroundBar SDA. Use the 5' analog L/R audio
cable provided.
9 Power Connection—The SurroundBar SDA Power
Supply connects here.
10 Power Switch—Turns the SurroundBar SDA on or off,
but you can leave it on all the time.
4 Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
2 3 4 5
MUTE REMOTE
CHANNEL ID
1 2 3 4
6
® SDA ® or puts
R
24V......
2.7A
GAIN LEVEL
L
INPUT
1 2 3
7 8 9
SurroundBar SDA LED

NORMAL MODE:

Green Steady—Power is on; all is well.
Red Steady—Power is on but no audio signal detected.
Green Two Blinks—A remote control signal
is received successfully.
Green Slow Blinking—System muted.
Green Fast Blinking (After pressing volume up
button)—You have reached the maximum volume.
Green Fast Blinking (At power up)—SurroundBar SDA and
wireless subwoofer have established a wireless connection.
Orange Fast Blinking (At power up)—
SurroundBar SDA and wireless subwoofer have
failed to establish a wireless connection.
LEARNING MODE: (See page 9 for instructions.)
Orange Blinking—The SurroundBar SDA is in learning mode.
Orange Steady—The SurroundBar SDA is in learning mode
and a SurroundBar SDA button has been selected.
Green Blinking—The SurroundBar SDA has successfully
learned a remote control command.
Red Blinking—The SurroundBar SDA has failed to learn
a remote control command.
Red and Orange Blinking—Learned IR codes have
been successfully erased.
POWER
10