Marechal Electric DS1 Mode D'emploi page 21

►OPERATION (2/3)
• To connect, align the red marks on the housings. Insert the
device and turn clockwise until the stop. The device is in the
rest position, circuit open.
• Push the device fully home until latched. If any, use the
finger draw plates or the draw-and-lock levers. The finger
draw plates must be assembled on the devices as follows.
• To disconnect, disengage the draw-and-lock levers and
depress the latch. The device returns to its rest position.
• Turn the device in
the opposite
direction to remove
it. Shut the lid.
,
IS 06-1 [DS1/DS3/DS6/DS9] Rev A.0 - 2022-02 21/85