Instruction Warnings; Safety And Right Use Warnings; Warranty; Installation - ROCAM VULCANO 1/1 Manuel D'instructions

1. Instruction Warnings

The final user has to hold the whole instructions. User must store up this document in case
of use. Producer do not assume any responsibility for damages incurred due to the failure
of improper use of this manual. All measures in this manual are in mm.

2. Safety and Right Use Warnings

The Rocam Losi products meet the latest technological evolutions and
current safety guidelines. The carving stations VULCANO, object of this
booklet, are projected to be in compliance with directives and field laws, in
order to guarantee a safe and reliable product. Any other use will be
considered inapposit to the original destination. Producer do not assume any
responsibility for damages caused by an improper use. Responsibility lies
only on user. A proper use also includes compliance with the instructions for use and
installation and any additional documentation as well as the conditions of inspection and
maintenance.

3. Warranty

We thank you for purchasing a Rocam Losi product, designed and produced for a
professional environment. Due to commercial and construction requirements, the
manufacturer reserves the right to make changes in order to enhance the quality and use
of product. Rocam Losi s.r.l., in compliance with European Community legislation,
guarantees its products for 24 months. This guarantee does not include electrical parts,
labor and all replacements related to an improper use of the good.
Any manipulation carried out automatically excludes the liability of the manufacturer. The
products or parts to be replaced or repaired for unequivocal defects in workmanship and
materials used must be in a "free port" at the offices of the producer, who after a careful
inspection, will repair or replace them. The repairs are carried out exclusively at the
headquarters of the manufacturer, and none cost incurred by the customer for repairs will
be refunded by the manufacturer unless expressly agreed.

4. Installation

The manufacturer declines every responsibility of damage of someone or
something caused by the failure to comply with the instructions of this
manual.After the unpacking of the item from its packing, proceed by
removing the adhesive plastic tape before sarting up the product. Any
residual glue has to be removed carefully (do not use abrasive cleaners).
The device is designed to run on AC to the voltage specified on the technical data plate
(located on the bottom of the unit). The grounding line is marked by the colours
yellow/green and must not be interrupted. The device is provided with a cable in
accordance with the CE regulations and with a CE and schuko plug (that can be replaced,
when necessary, with a different plug, suitable for the specified wattage and in accordance
to the current regulations and guidelines; when necessary, replace the provided cable with
a new one with the same features).
Before switching the applicance:
• Check if the electrical system can withstand the appliance's load (WATT as indicated
on the techical plate)
• Make sure that the electrical system is provided with ground connection according to
the current norms and guidelines.
2