Loading The Vu-V101 (Flashpath) - JVC FLASH PATH VU-V101 Mode D'emploi

FLOPPY DISK ADAPTER VU-V101

Loading the VU-V101 (FlashPath)

Inserting the VU-V101
Before inserting the VU-V101 into the floppy disk drive, thoroughly
wipe off any soiling of the rectangles in the top-center of the adapter
(the black area on the front and the cavity on the back).
Then insert the VU-V101 into the floppy disk drive. The VU-V101 is
now ready to be accessed by the floppy disk drive.
NOTE To maximise the life of the batteries, always take the VU-V101
out of the floppy disk drive when the SmartMedia is not being
accessed.
Ejecting the VU-V101
After the VU-V101 has been ejected from the floppy disk drive,
thoroughly wipe off any dust or soiling that has collected in the
rectangular cavity in the top-center of the back of the adapter.
After cleaning the VU-V101, always remove the SmartMedia from the
VU-V101 and store the VU-V101 in its hard case.
NOTE
1. The VU-V101 does not have a write-protection mode. Even
if the SmartMedia card has a write-protect sticker affixed to
it, the VU-V101 will not recognize it.
Ensure that existing data is not inadvertently erased or
overwritten as a result.
2. Do not leave the VU-V101 in the floppy disk drive as this
could result in damage to the drive.
18
All manuals and user guides at all-guides.com