Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Translation of the original instructions
ATTACHING DISC PADS
1. Secure the Spindle with the flat wrench provided with the tool, and screw the Disc pad on. Tighten to firm hand-
tightness. Do not over tighten.
2. To remove the Disc Pad, insert the flat wrench between the Disc Pad and shroud. Secure the Spindle with the flat
wrench and unscrew the Disc pad. - see figure 5.
Figure 5
CLEANING
1. Periodically blow out all air passages and area above Disk Pad and under shroud with dry compressed air. All plastic
parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts.
2. Wear safety glasses while using compressed air.
HEALTH AND SAFETY INFORMATION
RoHS Compliant
This product and the associated component parts are "RoHS Compliant" and do not contain any of the sub
stances in excess of the maximum concentration values in EU Directive 2011/65/EU, as amended by Commis-
sion Decision 2005/618/EC and other amendments issued as of the date code marked on the product.
Waste Electrical & Electronic Equipment (WEEE) Compliant
•
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
•
Contact your local government for information regarding the collection systems available.
•
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
•
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for
disposal at least for free of charge
ELECTRIC DUAL ACTION (DA) SANDER
EN
11
Publicité
Table des Matières
