Midas DM16 Guide Rapide page 17

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
6. Operation
Basic Operation
1. Make sure the power to all devices is turned off!
2. Connect all appropriate power and audio cables to the mixer.
3. Set the controls with all knobs centered and all faders down/off.
4. Turn the mixer on.
5. Set the GAIN for each channel. (See the Gain Setting section for details.)
6. With the MAIN MIX faders and LOCAL MONITOR knobs all the way down, turn
on your PA system or monitors.
7. Slowly raise the MAIN MIX faders or LOCAL MONITOR knob to the
desired level.
8. Adjust the relative level of each channel by raising each CHANNEL FADER.
9. Adjust the left-right position of a channel in the stereo field if necessary by
turning the channel´s PAN or BAL knob.
10. For live applications, adjust the overall output from the mixer to the power
amp or powered speakers by raising the MIX faders. If the red +10 or +16
LEDs on the MASTER METERS light, lower the MIX faders.
11. Use the AUX 1 and AUX 2 knobs to send the channel signals out to an effects
processor or stage monitor connected to the AUX OUT jacks. If used for
effects, route the signal back from the processor to the STEREO 1 or STEREO
2 inputs.
Gain Setting
1. Press the Channel 1 PFL (Pre-Fader Listen) button to solo the channel for
gain setting using the MASTER METERS. The PFL LED in the MASTER METERS
section will light up.
2. Sing, speak or play at a normal level through the microphone or instrument
connected to Channel 1.
3. While singing or playing, turn Channel 1´s GAIN control. The MASTER METERS
will display the signal level. Set the GAIN control so that the loudest peaks
reach 0 on the MASTER METERS.
4. Press the Channel 1 PFL button again to deactivate Pre-Fade Listen mode for
that channel.
5. Repeat Steps 1-4 for any other channels that will be used.
17
Quick Start Guide

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dm12

Table des Matières