Omega 42001 Manuel Des Consignes D'utilisation Et Des Pièces page 4

Bleeding / Venting Trapped Air of a Service Jack
With the release valve in the OPEN position (3b.) and with saddle fully lowered, locate and remove the oil
filler plug. Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within the
reservoir. Reinstall the oil filler plug.
• Read, understand, and follow all printed material provided with and on this product before use.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Adequately support the vehicle before starting repairs.
• If loaded jack must be moved, make certain that load is secured by appropriate means, is stable, is in
the lowest possible position, is moved over a smooth, hard level surface and that the lifting platform
is level.
• Use of this product is limited to removal, installation, and transportation of automotive and light
truck transmissions, transfer cases and transaxles.
• Use only adapters / accessories provided by the manufacturer of this transmission jack.
• Use only adapters / accessories whose rated capacity is greater than the rated capacity of this jack.
• Ensure the center of gravity is center loaded on the saddle.
• Never use this device as a work/repair station. Transfer the load immediately to a suitable work station.
• No alteration shall be made to this product.
• Failure to heed these markings may result in personal injury and/or property damage.
OPERATION
Follow the instruction for removal and installation of transmission, transfer case or transaxle according to the vehicle
manufacturer's service manual.
Raise saddle assembly:
Pump foot pedal or press air pump pedal (Model 42001) until saddle reaches desired position.Secure load with
provided chains.
Note: DO NOT OPERATE BY AIR AND BY FOOT PUMPING AT THE SAME TIME.
Ensure center gravity of load is centered on the saddle and load is stable before moving jack. An off-center
!
transmission could cause the jack to tip or flip over .
Lower saddle:
Be sure all tools and personnel are clear before lowering load. Slowly engage release valve pedal!
!
Maintain control of the rate of speed at which the load lowers at all times!
Slowly, gently apply downward pressure to the release valve pedal.
!
Never use this jack as a workstation!
WARNING
!
WARNING
!
To avoid crushing and related injuries:
• Never work on, under or around a load supported only by hydraulic jack.
• Be alert and sober when using this product. Do not operate under the
influence of drugs or alcohol.
4