Operating Instructions & Parts Manual
General Safety
CAUTION
!
ardous situation which, if not avoided,
MAY result in minor or moderate
injury.
NOTICE
mation that, if not followed, may
cause damage to the equipment.
1. Read all instructions and
safety precautions before
operating the unit.
2. Keep visitors away and NEVER allow
children or pets in the work area.
3. Do not smoke or eat when spraying
paint, insecticides, or other flamma-
ble substances.
4. Always work in a clean environ-
ment. To avoid injury and damage
to the work piece, do not aim the
spray gun at any dust or debris.
5. When spraying and cleaning, always
follow the instructions and safety
precautions provided by the materi-
al manufacturer (refer to Material
Safety Data Sheet).
6. Avoid spraying paint on windy days.
This will prevent overspray from
getting on surrounding vehicles,
buildings, and other objects.
WARNING
!
during shipping, handling or use.
Length of Cord (ft) 25-50 50-100 100-150 150-250 250-400 400-500
Gauge of Cord
www.chpower.com
(Cont.)
Caution indicates
a potentially haz-
Notice indicates
important infor-
MANUAL
Do not operate
unit if damaged
Extension Cords for 120V/15 Amp Unit
18
ELECTRICAL SAFETY GUIDELINES
DANGER
!
ELECTRICAL SHOCK HAZARD:
To prevent electrical shock,
observe the following guide-
lines at all times:
• Follow all local electrical and safety
codes, as well as the National
Electrical Code (NEC) and, in the
United States, the Occupational
Safety and Health Act (OSHA).
• This product requires a grounded
120V, 15 amp circuit and requires
the use of a grounded three-wire
extension cord in good condition
(see Figure 1). (Note: See chart
below for proper extension cord
lengths.) If the power receptacles
available will not fit this type of
cord, then have an appropriate
power receptacle installed by a cer-
tified electrician.
Figure 1 - Grounded three-wire
extension cord
• Only qualified electricians or service
personnel should perform mainte-
nance on the electrical components
of this system.
• Do not modify any of the electrical
components of this equipment.
16
14
2
TEST
RESET
12
10
8