General Notes; Setting Up For Installation - Dalla Corte Evolution Notice Pour L'utilisateur

General notes

The manufacturer has the right
to modify this manual without
updating previous editions.
Read carefully the manual of
instructions and warnings for
the use and maintenance of the

Setting up for installation

Place the machine on a surface
that guarantees a secure sup-
port.
To get ready for set up, make
sure you have an opening A Pic.1
on the support surface to allow
connection with systems in the
space below B Pic.1.
The machine should be con-
nected to a source of softened
cold drinking-water.
machine, since an improper use
could cause damage to people,
animals and things.
The manufacturer cannot be
held responsible for that.
The water pressure should be
between 1 and 4 bar. If this is
not possibile, please contact the
manufacturer.
A tap should be placed on the
water supply (1 Pic.1) so that the
water passage can be closed in
case of need.
The discharge siphon should
have a 40 mm (5 Pic.1) diame-
ter which should be connected
to the drainage set up (4 Pic.1).
The machine is not endowed
with a plug (6 Pic.1), to be con-
nected in a fixed manner to the
electrical supply, therefore one
must have an installation on/off
switch (7 Pic.1).
23