Ferplast PICO EVOMAG 650/180 Manuel D'utilisation page 8

• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be
made by children without supervision.
• Keep the appliance and its cord out of reach of
children less than 8 years.
IMPORTANT - Within the European Union, a crossed-out wheelie bin symbol on
the product, documentation or packaging indicates that the product cannot be
disposed of in the regular household waste stream, in compliance with EU Directive
2012/19/EC and with current local regulations. The product must be disposed of at
recycling centres or authorised waste disposal centres for electrical and electronic equipment, in
accordance with current legislation in the country where the product is found. Incorrect disposal
of this type of waste can have a negative impact on the environment and human health, caused
8 English
by the potentially hazardous substances produce by electrical and electronic equipment. Correct
disposal of these products will also contribute to the efficient use of natural resources. Further
information is available from the product retailer, the competent local authorities and national
manufacturer's organisations.
INSTALLATION
ATTENTION: PLEASE VERIFY THAT ALL COMPONENTS OF THE PUMP ARE UNDAMAGED
BEFORE PUTTING IT INTO FUNCTION. BEFORE ANY KIND OF INTERVENTION, ALWAYS
DISCONNECT ELECTRICAL SUPPLY OF THE PUMP AND ANY OTHER APPLIANCE PLACED
IN THE WATER. BE SURE THAT THE VOLTAGE OF THE MAINS SUPPLY CORRESPONDS TO THE
VOLTAGE SHOWN ON THE UNIT'S LABEL. IN ORDER TO PREVENT NOISE AND DISTURBANCE
CAUSED BY VIBRATION WE SUGGEST TO POSITION THE PUMP AVOIDING LATERAL CONTACT
WITH THE AQUARIUM GLASS OR IN AN UPWARD POSITION ON THE BOTTOM.
• Unwind the electric cable.
• Insert the rotation sphere of the base in the proper slot on the suction cup-magnet support.
- Fig. 2/2a -
• Immerse the pump completely and turn it in a vertical position in order to allow any air to
come out of the impeller chamber.
• Attach the pump with the internal part of the suction cup + magnet support to the aquarium
side as desired - Fig. 3/3a - (remember to clean the surface before attaching the support).
• Holding with one hand the pump attached inside the aquarium, place the external part of
the magnetic support on the outside of the aquarium at a distance of approx. 10 cm (3.93
inches) from the centre of the internal support. Slowly move the external support until you
feel the attraction between the magnets and place them so that the centres are on the same
axis. - Fig. 4/4a -
• Direct the water flow as desired.
• Connect to electrical supply.