Technical Specifications - PNI S916 Manuel Utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
3. After setting destination, if the program does not route successsfully,
failure positioning might be the reason, make sure the device gets the
GPS signal fixed then start routing again.
Note!
Before first use, charge the device at least 5 minutes with the device
powered off, so the device will have enough start up power.
For first time use, go outdoors to an open area, turn on the device and
wait for 2~5minutes to fix the GPS location.
Caution
The device works with the Android operating system and has pre-installed
two android navigation apps: Waze and Here WeGo Maps. For the correct
use consult the terms and conditions of use of these Android apps.
Because these apps work with information downloaded from the internet you
have to connect both at first use and occasionally the PNI S916 GPS to
Internet by wifi in order to download necessary maps, and for updating the
information about maps, routes and traffic.
Do not install the device in front of an airbag.

Technical specifications

Processor
Operating system
Display
Memory
Extended storage
Battery
Cortex A53*4 1.3GHz
Android 6.0
7inch 800*480 px
RAM 1GB DDR3, ROM 16GB Nand Flash
Micro SD card, max 64GB
3.7V 2000mAh
EN

Publicité

Table des Matières
loading

Table des Matières