Using The Audio Input; Other Buttons On The Device - TechniSat AUDIOMASTER MR3 Mode D'emploi

6.6 Using the audio input

It is possible to play sound from external devices using the analogue audio output.
> Connect the external device to the AUX IN connection (11), (3.5mm jack) on the device rear.
> In Source selection tap the AUX IN item.
To set the volume optimally, use the volume control both on the device and on the connected external
device.
Please note that if the volume on the connected device is very low, while the speakervolume setting is
higher, annoying noises/background noise will be amplified and, therefore, will clearly be heard. It is
recommended that you set the speaker volume, e.g. on an Internet radio station, switch to the audio input
and then to adjust the volume of the connected device in such a way that the overall volume of the audio
input corresponds approximately to the volume of the Internet radio station. In this way, you can also
avoid considerable differences in volume when switching between the speaker functions.

6.7 Other buttons on the device

The following buttons can be found on the top of the device:
> VOL - (10), volume control, down (TECHNISOUND MR2 only)
> VOL +(9), volume control, up (TECHNISOUND MR2 only)
30