Activating The Set-Up Mode - TechniSat AUDIOMASTER MR3 Mode D'emploi

5.1 Activating the SET-UP mode

> The device is in SET-UP mode when started for the first time.
AUDIOMASTER MR1/MR2/MR3:
The On/Standby status display on top of the device flashes blue and the Internet radio symbol is
permanently lit (the device takes a few seconds to start).
TECHNISOUND MR2:
The Internet radio symbol on the top of the device flashes (the device takes a few seconds to start).
In this mode, the device acts as a WLAN AccessPoint and is ready for installation.
> To switch the device to SET-UP mode after the first installation:
AUDIOMASTER MR1/MR2/MR3:
Press and hold the On/Standby/Volume up/down knob for approx. 10 seconds until a warning sound
is heard. After a brief starting phase, the On/Standby status displayl on the top of the device flashes blue
and the Internet radio symbol illuminates permanently.
TECHNISOUND MR2:
Pull out the mains plug, then hold down the On/Standby (4) button on the device. While doing so,
insert the mains plug in the socket again. Approx. 5 seconds after the device has been supplied with
power again, release the On/Standby button on the device. After a brief starting phase, the Internet radio
symbol on top of the device starts flashing.
The device is reset and restored to its delivery status, thereby cancelling all settings previously made.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
21