Profile FUGA PAC313 Mode D'emploi page 21

1
PROGRAMMING
A
B
BEEP BEEP
♫ ♫
C
NOTE :
When you replace or remove the batteries from the bell unit please always re-follow the above
steps to programme the bell.
2
DELETE PROGRAMME
3
PROGRAMMING MULTIPLE BELLS
Repeat steps 1A - 1C for all bells. Do this per bell in order to avoid interference.
Access the button by pressing in the tab on the side and
removing the insulating strip.
Slide open the lid on the back. Insert 2 alkaline batteries
into the battery compartment. The bell will not make a
sound. The bell is ready to learn and memorise the digital
code.
Within a minute, push the button. The bell will play a ring-
tone. It is now programmed. Leave it for 5 minutes before
reusing it.
To delete a programme, remove the batteries from the
button and the bell. Press the button for 10 seconds. Leave
both for 30 seconds.
UK