Safety Instructions - auna multimedia Kara Projectura Mode D'emploi

Protection against laser energy exposure
• As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disas-
semble the casing .
• Stop operation immediately if any liquid or solid object should fall into the cabinet .
• Do not touch the lens or poke at it . If you do, you may damage the lens and the player may not oper-
ate properly .
• Do not put anything in the safety slot . If you do, the laser diode will be "ON" when the CD door is
still open .
• If the unit is not to be used for a long period of time, make sure that the power source is disconnected
from the unit . Unplug the AC cord from the wall outlet . Make it a practice to remove the AC cord by
grasping the main body and not by pulling the cord .
• This unit employs a laser . The use of controls or adjustment or performance of procedures other than
those specified here may result in exposure to hazardous radiation.
Placement
• Do not use the unit in places which are extremely hot, cold, dusty or humid .
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in a place with poor ventilation, by covering it with
a cloth or by placing it on a carpet .
Condensation
• When left in a heated room where it is warm and damp, water droplets or condensation may form
inside the unit .
• When there is condensation inside the unit, the unit may not function normally .
• Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the
unit before use .
Should any trouble occur, remove the power source and refer servicing to qualified personnel.
Protect your furniture
• This system is equipped with non-skid rubber 'feet' to prevent the product from moving when you
operate the controls . These 'feet' are made from non-migrating rubber material specially formulated
to avoid leaving any marks or stains on your furniture . However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave
marks or a rubber residue on the furniture .
• To prevent any damage to your furniture we strongly recommend that you purchase small self-adhe-
sive felt pads, available at hardware stores and home improvement centers everywhere, and apply
these pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture

Safety Instructions

25