BOHELL TP710REA Mode D'emploi page 16

label matches the mains voltage before plug-
ging in the appliance.
- Ensure that the selected tension on the voltage
selector coincides with the tension of the mains.
INSERT A DRILL BIT:
- To open the drill's chuck, whilst completely
switched off, take firm hold of the back part of
the chuck and turn the front part of the chuck
counter clockwise.
- Insert the drill bit, screwdriver bit, or other tool/
accessory required for the task, into the chuck.
In order to obtain a secure fastening of the bit,
insert the bit as far as you can into the chuck.
Take firm hold of the back part of the chuck and
turn the front part of the chuck clockwise until it
is firmly closed.
- In order to remove accessories from the chuck,
follow the same steps as indicated previously
but in reverse order.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the start-up button.
LIGHT FUNCTION:
- The appliance includes a light function, which il-
luminates the working area under the appliance.
ADJUSTMENT OF DEPTH
The drilling depth can be controlled by the depth
stop (H). To do it, first do one incision with the drill
bit to another surface (normally a piece of wood)
and adjust the depth you desire on it. After you
can operate with this adjustment to the surface
you need to drill.
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated
by using the speed regulator control (A). This
function is very useful, as it makes it possible to
adapt the speed of the appliance to the type of
work that needs to be done.
DRILLING, DRIVING AND IMPACT DRILLING
DRILLING:
- Turn the selector (E) until the arrow on the
appliance points to (
IMPACT DRILLING
- Turn the selector (E) until the arrow on the
appliance points to (
)
)
LOCKING BUTTON:
- Activating the locking button allows you to
operate the appliance without having to depress
the run button.
- To activate this function press button (C) while
holding down the start-up switch.
- To deactivate this function, press the run button
right down.
ROTATION DIRECTION CHANGE:
- By using the rotation direction switch (D) you
can make the impact drill rotate clockwise or
counterclockwise. To do it, change the side of
the rotation direction switch.
ONCE YOU HAVE FINISHED USING THE SE-
LECT THE MINIMUM POSITION (MIN) USING
THE SPEED CONTROL.
- Stop the appliance by releasing the on/off
switch.
- Unplug the appliance from the mains.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
- These supplies are available in specialist shops.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.