Forza FRT304GN Utilisation Et Entretien page 19

Following there is a procedure:
1) Remove the burner cap from the burner base and clean according to cleaning section.
2) Remove the burner spreader. Clean the gas tube opening and burner port according to cleaning section.
3) Clean the burner base with a damp cloth (keep the gas injector area free of cleaning agents and any other material
from entering the injector orifice).
4) Replace the burner spreader and cap, making sure the alignment pins are properly aligned with the slots.
5) Turn on the burner.
If the burner does not light, check cap and spreader alignment. If the burner still does not light, do not service the gas burner
yourself. Contact a trained repair specialist.
Be sure when lighting the burner:
• Gas spreader is seated correctly and pin is properly aligned with burner base slot.
• Cap is seated correctly and pin is properly aligned with gas spreader slot.
Burner Ports
Check burner flames occasionally. A good flame is blue in color, not yellow. Keep this area free of soil and do not allow spills,
food, cleaning agents or any other material to enter the burner ports.
EN
19