AniOne Keramik Trinkbrunnen Flow Mode D'emploi page 32

OPERATING INSTRUCTIONS FOR YOUR ANIONE CERAMIC DRINKING FOUNTAIN FLOW
As with any electrical device, check the power cord for any tears or damage before use.
1. Rinse the replacement filter thoroughly under cool water before placing it into the bottom bowl. Rinsing will remove most of the loose activated
carbon dust which is harmless to pets.
2. Take the cover off the drinking fountain and place it to one side (Figure 1).
3. The flow can be set using the control valve on the pump (Figure 2a). Connect the new filter to the pump after rinsing (Figure 2b) and connect the
clear tube to the water pipe of the pump nozzle (Figure 2c).
4. Place the assembled pump and filter inside the bottom bowl and press it down so that the suction cups stick to the bowl (Figure 3). Thread the
pump's power cord through the cylindrical hole in the bottom bowl and put on the rubber cover.
5. Place your finger on the nozzle of the top cover. Please make sure that the upper end of the clear tube lines up with the water spout of the top bowl
(Figure 4) and put the top bowl in position (Figure 5).
6. Place the fountain in its desired location. The use of a protective mat is recommended to protect your floor from splashes or drips which may occur
when in use.
7. Fill the unit with approx. 2 litres of water.
8. Plug the power cord into the adapter.
9. Please allow 1 to 2 minutes for the pump to start pumping once plugged in.
10. Add water as needed and always keep the fountain filled with water to 1.5 cm from the top edge of the bowl.
1 2a 2b 2c
3 4 5