Restore Factory Settings - Belkin OmniView SMB Mode D'emploi

Remote Installation

Restore Factory Settings

You can restore the IP Device to its original factory settings. This restores the
original parameters, resetting all the information added by the administrators,
including: network settings, servers, switches, users, and passwords. You also
have the option to preserve network settings, as explained below.
WARNING! Once data has been reset, it cannot be retrieved.
To restore factory settings:
1.
Select "Restore Factory Settings" in the far-left menu. The
Restore-Factory-Settings page will appear (see Fig. 9).
2.
Check the Preserve-Network-Settings box if you would like to preserve
the network settings.
3.
Click
Logging Out
To exit the Configuration page and close the session, click
Only one administrator can log into the Configuration area at a time. An idle
timeout of 30 minutes terminates the session.
UK-29
.
Fig. 9 Restore-Factory-Settings Page
.