POWER SMITH ASH VACUUM Manuel D'utilisation page 10

FLOOR/CARPET TOOL USE
The Floor Carpet Tool can only be used when attached to an extension tube. With vacuum set up for dry
vacuuming
1. Connect the extension tubes to one another; then, attach the fl oor/carpet tool to the narrow extension
tube end.
2. Slide the wide end of the extension tube into the hose.
3. Located on the left side of the fl oor/carpet tool is the brush position lever. Figure 7
- Push down the lever's front edge to retract the brush for vacuuming fl oors.
- Push down the lever's back edge to lower the brush for vacuuming carpets.
CREVICE TOOL
Use the Crevice Tool to vacuum material from narrow areas more effectively then the nozzle alone. The
narrow tip of the crevice tool also increases suction, which aids in vacuuming material in deeper cracks
& tight areas.
- Attach the crevice tool the narrow end of an extension tube to access hard to reach areas.
- Rotate the tools tip as the arrow indicates to position the brush end for use.
WARNING:
performing all maintenance procedures and when removing the motor housing.
IMPORTANT!
indoors in or near living areas.
CLEANING THE CANISTER AND FILTER
1. Unplug the vacuum from the power outlet.
2. Remove the hose from the vacuum port by rotating the hose coupling counter-clockwise.
3. Unclamp the motor housing and remove it from top of the canister.
Filter Cleaning
1. To minimize airborne dust, tap the inside of the fi lter bag with your fi ngertips to knock collected dust
into the canister.
2. Remove the fi lter bag from the canister and remove remaining dust by tapping the fi lter's interior or
lightly brushing off the outside of the bag.
NOTE:
3. If necessary, the fi lter may be hand washed with cool water & mild detergent, then gently
hand wring to remove excess water and set aside to air dry. Be sure the fi lter is dry before use.
DO NOT machine wash/dry the fi lter!
NOTE
4. : Do not use compressed air to clean the fi lter.
Canister Cleaning
1. Dump the cold ash from the canister into an appropriate disposable container such as a plastic or
paper trash bag.
2. To remove ash clinging to the canister interior, light wipe off the dust with paper towels or cloth rag. If
necessary, a slightly moist towel or rag may be used to wipe off the canister interior & exterior.
3. Do not wash the canister with water, cleaning agent, or other liquid.
Inspect the fi lter for tears or holes; if any are found, replace the fi lter before reassembly of the Ash
Vacuum.
MAINTENANCE
Always disconnect the plug from the power outlet before
All cleaning and maintenance procedures should not be done
English
10