Programme; Anti Legionnaire's Disease; Optimizer Energy Plus; Fault Warnings - Rointe RD Serie Manuel D'instructions

Series

3.2.3. Programme

When the indicator is on, it means that the Rointe RD Series water heater has been programmed using
the M Series Remote Control. Please refer to its manual for further reference about how to programme the
Rointe Digital System.

3.2.4. Anti legionnaire's disease

Our RD Series is designed with safety in mind, and all the anti legionnaires' disease regulations are
complied with. Each day the water heater is automatically set to its maximum temperature for an hour,
whilst this mode is active you will se the 80ºC temperature led blinking.

3.2.5. Optimizer Energy Plus™

This product includes Optimizer Energy Plus™ technology to efficiently manage the energy consumption
of the water heater.

3.3. Fault warnings

During normal equipment use, without any intervention by the user it is possible to detect faults which
are shown using the LEDs.

3.3.1. Temperature probe failure

When the temperature probe fails, the temperature setting LEDs flash every half a
second.

3.3.2. Electronic circuit failure

When there is a failure in the electronic circuit, the heater in use LED flashes every
half a second.

4. MAINTENANCE

The heater does not need any special maintenance, except an annual inspection of the magnesium
anode. In order to clean it rub with a soft cloth or damp sponge. Do not use abrasives or detergent.
The electric water heater guarantee is 7 YEARS for the water tank and 2 YEARS for the electronics from
the date of purchase. If the water heater breaks down during this guarantee period the entire appliance
will be replaced. In the Canary Islands, the water tank is guaranteed for 3 YEARS.
In order to guarantee the life of the water heater, it is a requirement that the user agrees to an annual
inspection of the magnesium anode to check for erosion. Where erosion is excessive, it should be
replaced.
Our guarantee will be applied with the express condition that the electrical heater has been well installed
by QUALIFIED FITTERS and with the PROTECTIVE SOCKETS which are provided with the appliance and
that there has been an initial inspection of the anode.
Excessive heating by a possible failure of the thermostat, is protected by the safety limiter, that cuts the
two phases and leaves the heater without electrical supply. Should this occur, call the Client Assistance
Service to arrange repair.
20