Use; Operation; Electronic Control Function; Front Panel Description - Rointe RD Serie Manuel D'instructions

Series

2. USE

2.1. Operation

Filling. Once the heater has been installed, open the stop cock. Then open the hot water taps. When
the water begins to come out of them the heater is full. Close the taps and check thoroughly that there
are no leaks in the installation. Do not connect the heater to the mains supply before ensuring that it
is full of water.
Electrical connection. Plug in the heater, switch on and leave the appliance connected to the electricity
supply. Once a certain amount of hot water has been used, the thermostat switches the heating element
back on.
Draining. In prolonged periods without use, and if there is risk of frosts in the premises where it is
installed, the heater must be drained. It is possible to do this using the safety valve.
In all cases:
• Cut the current
• Close the tap where water enters the Installation.
• Drain through the safety group using the lever.

3. ELECTRONIC CONTROL FUNCTION

3.1. Front panel description

The following image shows how the front panel of the water heater looks:

3.1.1. Front panel indicators

Section Description
Set temperature indicator
Amount of hot water available
ON / Stand by indicator
Heater element in use indicator
Programme indicator
18