Publicité
Les langues disponibles
Les langues disponibles
ARCS / ARCS Blue
Upgradable readers
Installation instructions
Clips
Slots
- Disconnect the flat flexible antenna cable from connector J6.
- Remove the core from the front part (steps 1, 2).
- Install the core in the keyboard front part.
- Connect the flat flexible antenna cable to connector J6 and the
flat flexible keyboard cable to connector J7.
Disconnect the flat flexible antenna cable of connector J6.
-
- Remove the core from the front part (steps 1, 2).
- Install the core in the screen front part.
- Connect the flat flexible antenna cable to connector J6 and the
screen ribbon to connector J14
-
Pass the cables through the hole in the base.
-
Screw the base in its final location.
-
Connect the reader.
-
Test the readings and communication.
-
Place the reader on the base (clip the top part and then pivot it down).
-
Lock the reader with the two screws provided using the specific tool.
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1114C06- Page 4 sur 15 - Ed. 04/04/2019
STid reserves the right to make change without notice, for the purpose of product improvement.
ARCS / ARCS Blue
Lecteurs évolutifs
Notice d'installation
Steps to remove the core from the front cover
Step 1
Procedure to install the core into the front part
Place the core between the two slots at the top
of the cover.
Procedure to change the front part
.
Mounting
ARCS / ARCS Blue
Lectores escalables
Procedimiento de instalación
conforme con NOM-024 -SCFI-2013
Step 2
Do not use the buzzer as a lever
And then pivot the core and press to insert it
between the two clips.
- Disconnect the flat flexible antenna cable from
connector J6 and the flat flexible keyboard cable
from connector J7.
- Remove the core from the front part (steps 1, 2).
- Install the core in the screen front part.
- Connect the flat flexible antenna cable to connector
J6 and the flat flexible screen cable to connector
J14
.
US
FR
ES
Publicité
