Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LoRaWAN PULSE - Mode d'emploi / User guide version V1.5
2.4. Configuring the LoRaWAN PULSE unit
our LoRaWAN PULSE is configured via the combination of switches. The following settings can be changed:
•
The meter type
•
The pulse width
•
The transmission period
Note: configuration via switches lets you use 2 meters of the same type (2 water, 2 gas, ...).
CONFIGURATION TABLE:
Parameter
Meter type
Pulse width
Transmission period
NB: You must set your switches before activating the meters. Once the fraud wire for each of the meters has been installed and the LoRaWAN
PULSE has been started via magnet, the configuration with the switchs can no longer be possible.
If the configuration has any difference between the switchs and the product register value, the consistency error bit will be set to on in the
frame. This consistency verification is carried out every minute.
2.5. Closing the casing
Once stages 3.2, 3.3 and 3.4 have been carried out, you can close the casing of the LoRaWAN PULSE unit.
Procedure:
•
Make sure that the seal is properly positioned on the base
Value
Electricity
Water
Gas
Heat
3
1L / 10dm
/ 1Wh
3
10L / 10dm
/ 10Wh
3
100L / 100dm
/ 100Wh
3
1000L / 1m
/ 1000Wh
12h
30mn
15mn
10mn
SW1
SW2
SW3
ON
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
OFF
ON
ON
Seal
SW4
SW5
SW6
OFF
ON
OFF
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
Page
32
of 41
Publicité
Table des Matières
