Guarantee; Disposal - Waeco MagicTouch MT2000 Instructions De Montage

MT-2000.book Seite 24 Freitag, 12. Mai 2006 4:55 16

Guarantee

➤
Connect the yellow cable to the right indicator wire.
➤
Connect the black cable to earth (terminal 31).
➤
For positively switched indicators:
Always place the jumpers in the right position (fig. 3 A, page 4).
➤
For negatively switched indicators:
Always place the jumpers in the left position (fig. 3 B, page 4).
Note
For negatively switched indicators, check if the voltage in the wires from
the indicator switch (fig. 7 5, page 7) to the indicator control unit
(fig. 7 4, page 7) is less than 8 V when inactive.
If so, you must solder the diodes supplied into the original wires between
the indicator switch and the indicator control unit (fig. 7 8, page 7).
8 Guarantee
Our general guarantee conditions apply. If the product is defective, please send it
back to the WAECO branch in your country (addresses on the back of the operating
manual) or to your dealer. For repair and guarantee processing, the following docu-
ments must be sent along with the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
9

Disposal

➤
Place the packaging material in the appropriate recycling waste bins wherever
possible.
If you wish to finally dispose of the device, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
24
MagicTouch MT2000