Connecting The Comfort Indicator Module - Waeco MagicTouch MT2000 Instructions De Montage

MT-2000.book Seite 22 Freitag, 12. Mai 2006 4:55 16

Connecting the comfort indicator module

7 Connecting the comfort indicator module
The comfort indicator module is connected to the central locking with cable set 1 (6
wires). If you do not want to use the central locking confirmation function, you do not
need to connect this cable set.
Cable set 2 (5 wires) is for connecting to the vehicle indicators.
7.1 Connecting to the central locking (cable set 1)
Key for the circuit diagram for connection to the central locking:
No. in
Description
fig. 5, page 5
1 Comfort indicator module
2 6-pin plug for cable set 1
3 Terminal 30, +12 V
4 Left indicator
5 Right indicator
6 Central locking control device
7 Opening signal +12 V
8 Closing signal +12 V
rt Red
or Orange
ge Yellow
gu Green
we White
sw Black
➤
Insert the cable set 1 plug into the socket 1 on the comfort indicator module
(fig. 3 1, page 4).
➤
Connect the red cable to a permanent +12 V cable (terminal 30).
➤
Connect the orange cable to the right indicator wire.
➤ Connect the yellow cable to the left indicator wire.
➤
Connect the green cable to the central locking wire, where there is a brief signal
of at least +12 V when opening.
➤
Connect the white cable to the central locking wire, where there is a brief signal
of at least +12 V when closing.
➤
Connect the black cable to earth (terminal 31).
22
MagicTouch MT2000