Horizont trapper B12 Notice D'utilisation page 5

EN
Operating instruction for electric fence controller "trapper B12"
en relation avec les conseils de sécurité SECURA ANIMAL
ou SECURA SECURITY (www.horizont.com/securaanimal ou
www.horizont.com/securasecurity)
Energizer has to be turned OFF before any intervention!
The fence controller can contain domestic animals as cows and horses. It is supplied by a dry battery of 9 Volts or 12 Volts.
The controller delivers high voltage pulses into the connected fence with a sequence. The pulses are able to penetrate the
insulating hide of the animal and to provide shock pulses if the fence is orderly installed. The output pulses have constant
performance even if the battery voltage is decreasing.
Installation: Drive the ground rod until it stops into a wet place close to the
energizer. It is recommended to use an additional 1m rod (1a) under dry
conditions (see Fig. 1), and in case of long fences and dry conditions use an
additional ground wire (2a) with intermediate rods (2b) (see Fig. 2).
Opertation and control: Turn on with button (Fig.3 / 3a). After few seconds
a green LED is flashing with the pulses (see window 3a). The controller
gives pulse into the fence.
If there is no flashing either the battery is flat or there is a fault in the con-
troller.
Changing the battery (Fig.6): Separate the upper energizer unit from the
battery housing and change the battery - mind the right polarity, red to +.
Press the upper part onto the lower part and press until the snaps engage
with an audible click.
Standards: The energizer conforms to the european safety and EMC standards, it is CE marked.
SERVICE:
Repair is only to be made by qualified service personnel.
Only by the manufacturer commanded replacement parts must be used.
SUBJECT TO TECHNICAL ALTERATIONS !
trapper B12
5