Technical Specifications - MetaSystem Whad 800 ESP Manuel D'installation Et D'utilisation

V81606A Ist.Uso Whad1000:V81606A Ist.Uso UPS Whad1000
Construction specifications
Weight
Size L x H x P in mm
Technology
Computer interface
Protection features
Internal, synchronised bypass
Environmental specifications
Maximum altitude for storage
Storage temperature range
Operating temperature range
Range of relative humidity for operation
Grade of protection according to IEC529
Noise level at 1 metre
Nominal input voltage
Nominal input voltage
Range of input voltage
Nominal input frequency
Nominal input current
Maximum input current
Distortion of input current
with nominal load
Input power factor
In-rush current
Number of input phases
Line fuse
Battery charger direct from mains

TECHNICAL SPECIFICATIONS

Whad 800 ESP
PWM high frequency both for input stage and output stage.
Standard serial RS232 for interfacing with personal computer
using the diagnostic software supplied, output to 9 pin, female,
SELV insulated, DB9 connector
Electronic protection against overloads, short circuits and
excessive battery discharge.
Operation block at end of autonomy.
Inrush current limitation when switching on.
Sensor for correct neutral connection
Back feed protection (electrical insulation for the safety of
the input plug during operation in battery mode)
Intervenes in case of overload and operation anomaly
From 20% to 80% non condensing
From 184V to 264V with nominal load
From 110V to 264V with 50% of nominal load
50Hz/60HZ +/- 2% selectable by the operator
3 Arms
3.7 Arms
>0.99 at 80% of nominal load
100% of nominal current
Deeply discharged batteries are recharged in 12 to 15 hours
when mains power is present, even should the UPS not be
operating.
17
1-04-2008 15:47
Whad 1000 ESP Whad 1250 ESP
12 Kg.
160 x 319 x 402
Microprocessor control logic
Automatic
1000 metres
from -20°C to +50°C
from 0°C to 40° C
IP21
42 dBA
230V
3.7 Arms
4.5 Arms
<10%
Single phase
20 A FF
Pagina 17
4.6 Arms
5.7 Arms