Conditions For Use - MetaSystem Whad 800 ESP Manuel D'installation Et D'utilisation

V81606A Ist.Uso Whad1000:V81606A Ist.Uso UPS Whad1000
Congratulations on your choice to purchase a MetaSystem UPS !
This manual contains information regarding the safety, installation and operation of the Whad series of Unin-
terruptible Power Supplies manufactured by MetaSystem.
We recommend you read this manual carefully before proceeding to install your Uninterruptible Power Sup-
ply and then to follow its instructions scrupulously.
The Whad series of UPS have been designed principally for use in civilian, industrial and electro-medical ap-
plications; however, it is important to establish if there are particular regulations that apply to the latter ap-
plication in the country where the UPS is to be used.
Should there be a problem with the UPS we recommend reading this manual before contacting your service
centre: the section on 'Possible problems and solutions' can help resolve the majority of potential difficulties
experienced during the use of UPS.
Important
We recommend you keep the equipment's packaging materials as they can be useful should the need arise to
send the product back for repairs.
Damage caused by inadequate packaging of the UPS during transport is not covered by the guarantee.

CONDITIONS FOR USE

• The UPS was designed to supply power to appliances for data elaboration; the load applied must not exceed
that stipulated on the label located on the rear of the UPS.
• The ON/OFF button of the UPS does not electrically insulate its internal parts. To insulate the UPS, discon-
nect it from the mains power outlet.
• Do not open the UPS case since there may be energised parts inside it that are dangerous even when the
UPS is not connected to the mains power outlet. In any case, there are no parts inside the UPS that can be
repaired by the consumer.
• The front control panel is for manual operation: do not use sharp or pointed objects.
• The UPS was designed to operate in a clean, closed environment that does not contain inflammable liquids
and corrosive substances and is not excessively damp.
Fig.1
1
2
KEY
1 ON / OFF BUTTON
2 MULTICOLOR OPERATING STATUS INDICATOR LIGHT (GREEN/YELLOW/RED)
3 INPUT/OUTPUT PLUG-SOCKET
4 RS232 COMPUTER INTERFACE SOCKET
5 CONNECTOR FOR INSTALLATION OF ADDITIONAL BATTERY UNITS (optional)
6 FILTERED, NON-CONTINOUS, OUTPUT SOCKET (MAX 5 Arms)
1-04-2008
Fig.2
4
6
12
15:47 Pagina 12
3
5