Kübler CODIX 130 Mode D'emploi page 6

Main technical features:
Display: LCD, 8 decades, height of the figures 8 mm.
Display range:
-9999999 ... 99999999
with leading zeros suppression.
Overflow: In case of a display range overflow, the
counter starts again from 0, but without
removing the leading zeros and activating
all decimal points.
In case of a display range underflow, the
counter starts again from 0 and displays the
minus sign, without removing the leading
zeros and activating all decimal points.
Keys: Electrical locking of the reset key
Housing: Panel mounting, 48 x 24 mm
according to DIN 43 700, RAL 7021
Panel cut-out:
22,2 +0,3 x 45 +0,6 mm
Mounting depth: approximately 48 mm
Weight: approximately 50 g
Protection level: IP65 on the front side
Input specification, pin assignment and adjustable operating modes (DC versions).
A control input (screw terminal 5) allows adjusting the operating mode.
Screw terminal Nr. 1
Designation INP A
Model
6.130.012.8x0 07 kHz NPN
6.130.012.8x2 12 kHz PNP
6.131.012.8x0 07 kHz NPN
6.131.012.8x1 12 kHz PNP
6.133.012.8x0 03 kHz NPN
6.133.012.8x1 06 kHz PNP
Table 2
Screw terminals 1 and 2:
Function and max. frequences(Pulse/Pause 1:1)
see Table 2
NPN : active for negative edge
Input resistance: approximately 1 MOhm
Low level: 0 ... 0,7 V DC
High level: 3 ... 30 V DC
6
Connection:
EMC:
Low Voltage Directive (for the AC models):
Power supply:
Working temperature:
Operating temperature:
Storage temperature:
Backlighting:
Nr. 2 Nr. 3 Nr. 4
INP B Reset Reset
Enable
30 Hz NPN
NPN
07 kHz NPN
12 kHz PNP
03 kHz NPN
06 kHz PNP
PNP :
Input resistance:
Low level:
High level:
Screw terminals, RM 5.00, 8 poles
Rated cross-section: 4,0 mm
2,5 mm
AWG 12
Connection diameter:
0,4 ... 2,3 mm single-wire
AWG 28-12
Interference emissions EN55011 Class B
Interference resistance EN 61000-6-2
EN 61010 Part 1 ; overvoltage category 2,
contamination level 2
Non-replaceable lithium battery
(lifetime approximately, 8 years at 20°C)
–10 ... +55 °C, relative humidity < 85%,
without condensation
–10 ... +60 °C
–20 ... +70°C
external electrical source
(24 V DC ±20 %, 50 mA)
Nr. 5 Nr. 6 Nr. 7
Control inputs for operating GND
mode (Mode)
not active contact with
= GND =
adding subtracting
not active contact with
= GND =
Cnt.Dr Mode Up.Dn Mode
not active contact with
= GND =
Quad Mode Quad2 Mode
active for positive edge
approximately. 100 kOhm
0 .. 0,7 V DC
4 .. 30 V DC
2
single-wire
2 thin wire
Nr. 8
BL BL
– +