AirPro Progress Lighting P2588 Manuel D'installation page 8

Step 2. (Fig. 7) If your outlet box has a ground
wire (green or bare copper) connect it to the fan
ground wires; otherwise connect the hanging
bracket ground wire to the mounting bracket.
Secure the wire connection with a plastic nut
provided. After connecting the wires spread them
apart so that the green and white wires are on one
side of the outlet box and black wires are on he
other side. Carefully tuck the wire connections up
into the outlet box.
NOTE: Fan must be installed at a maximum
distance of 20 feet from the transmitting unit for
proper signal transmission
transmitting unit and the fan's receiving unit.
Code switch
(Located on
top of the motor)
Figure 6
5.
SUPPLY CIRCUIT
between the
Figure 7
TM
Finishing the Fan
Installation
GREEN GROUND
Step 1. Move fan into position over the four
mounting bracket and secure with the 4 screws
provided. (Fig. 8)
WIRING BOX
Step 2. Raise the motor housing up against the
GREEN GROUND
mounting bracket, the four supports inside the
housing should be placed against the four studs on
mounting bracket, twist the housing clockwise
GROUND TO
MOUNTING until snug (Fig. 9).
BRACKET
Mounting
bracket
Motor
assembly
Figure 8
Screws