Installing The Battery; Operating Your Transmitter 8 - AirPro Progress Lighting P2588 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing the battery

Install 12V MN21/A23 battery (included), to prevent
damage to transmitter, remove the battery if not used
for long periods.
Figure 14
Restore power to ceiling fan and test for proper
operation.
1. "
,
,
" buttons:
These three buttons are used to set the fan
speed as follows:
= Low speed
= Medium speed
= High speed
2. "
" button: (Fig. 14)
This button controls fan direction.
3. The "
" button turns the light ON or OFF and
also controls the brightness setting. Press and release
the button to turn the light ON or OFF. Press and
hold the button to set the desired brightness. The
light key has an auto-resume, it will stay at the same
brightness as the last time it was turned off.
Figure 15

Operating Your Transmitter 8.

4. "
" button:
This button turns the fan off.
NOTE: To operate the reverse function on this
fan, press the reverse button while the fan is
running.
Speed settings for warm or cool weather depend
on factors such as the room size, ceiling height,
number of fans, etc.
Warm weather - (Forward) A downward air flow
creates a cooling effect as shown in Figure 16.
This allows you to set your air conditioner on a
higher setting without affecting your comfort.
Cool weather - (Reverse) An upward airflow
moves warm air off the ceiling area as shown in
Figure 17. This allows you to set your heating unit
on a lower setting without affecting your comfort.

Publicité

Table des Matières
loading

Table des Matières