Unpacking; Assembly - Remington REM-80V-LPC-B Manuel De L'utilisateur Et Instructions D'utilisation

1. Remove all packing items applied to heater
for shipment. Keep plastic cover caps
attached to inlet connector and hose /
regulator assembly for storage.
2. Remove all items from carton.
Attaching The Upper Housing
• Tools Required: Phillips Screwdriver
1. Slide Upper Housing straight up and off of
lower housing and remove all packed items
from inside the heater (See Figure 2).
2. Remove all packaging protecting the heater
during shipping. Retain caps for covering the
inlet connector and regulator hose fro stor-
age.
3. Attach three (3) screws to the bottom row of
holes in the lower housing (See Figure 3).
Figure 2
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE

UNPACKING

ASSEMBLY

4. Slide upper housing over lower housing, lin-
NOTE: Save carton and packaging material for
later storage.
Figure 3
6
The Propane (LP) gas
CAUTION
pressure regulator and hose
assembly supplied with the heater must be
used without alteration.
ing up the four remaining screw holes. Insert
three (3) screws and tighten securely (See
Figure 3).
Convection Heater User's Manual