System Installation And Electrical Requirements; Electrical Code; Power Source - peerless-AV ULTRAVIEW UV492 Manuel De L'utilisateur

SYSTEM INSTALLATION AND ELECTRICAL REQUIREMENTS

Electrical Code

Note: To the display system installer: This reminder is provided to call attention to Article 820-44 of
the National Electric Code that provides guidelines for proper grounding and, in particular, specifi es
that the cable ground shall be connected to the grounding system of the facility. Outlet shall be
installed near the equipment and shall be easily accessible.
NEC National Electric Code
Ground clamps
Note: Installation shall incorporate UL Listed external surge protection rated 2500 Vpk or less, for 150
to 300 Vac mains, installed in accordance with Article 285 of ANSI/NFPA 70 or applicable local codes.

Power Source

The TV must be connected to a mains socket outlet with a protective grounding connection.
The mains plug is used as the disconnect device and shall remain readily accessible.
This display operates on 100-240 volts 50-60 Hz, AC current. Insert the power cord into a 120 volt
60 Hz outlet. Never connect the TV to direct current or anything other than the specifi ed voltage.
To prevent electric shock from the TV, do not use with an extension cord, receptacle, or other outlet
unless the blades and ground terminal can be fully inserted to prevent blade exposure.
WARNING
• Never remove the back cover of the TV as
this can expose you to very high voltages
and other hazards. If the TV does not
operate properly, unplug the TV and call
your authorized dealer or service center.
Ground clamp
Electric service
equipment
Antenna lead-in wire
Antenna discharge unit
(NEC Section 810-20)
Grounding conductors
(NEC Section 810-21)
Power service grounding
electrode system
(NEC Art 250 Part H)
3 2017-02-17 #:180-9099-1