Prepare The Tv For Usage; Remote Control Battery Installation And Replacement - peerless-AV ULTRAVIEW UV492 Manuel De L'utilisateur

Prepare The TV For Usage

1. Clean the TV with an approved screen cleaner and microfi ber cloth designated in the "Care of the
Screen" section. Do not use window cleaners or products containing ammonia.

Remote Control Battery Installation And Replacement

The remote control is powered by two 1.5V AAA
batteries installed at the factory.
To install or replace batteries:
1. To remove the battery module of the remote
control, remove the two screws on the end of
the battery module. Slide the battery module
out of the remote control.
2. Insert two new "AAA" size batteries into the
battery module.
3. Slide the battery module back into the remote
control and reinsert the two screws in the end
of the battery module.
CAUTION
Incorrect usage of batteries can result in leaks
or bursting. Peerless-AV recommends the
following battery use:
• Do not mix battery brands.
• Do not combine new and old batteries. This
can shorten the battery life or cause liquid
leakage of the batteries.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• Do not touch exposed battery acid as it
may injure skin.
• Remove the batteries if you do not intend
to use the remote control for a long period
of time.
C
POWER
MUTE SOURCE
TV DVD CBL AUX
VCR SAT
1 2 3
4 5 6
7 8 9
.
0
LAST
OK
VOL CH
+
INFO
EXIT
REW PLAY FF MENU
REC STOP PAUSE GUIDE
12
POWER
MUTE
TV DVD CBL
VCR SAT
1 2
4 5
7 8
.
0
OK
VOL
+
INFO
EXIT
REW PLAY FF
REC STOP PAUSE
2017-02-17 #:180-9099-1
SOURCE
AUX
3
6
9
LAST
CH
MENU
GUIDE