Starting The Welding Process - WELDY booster EX2 Notice D'utilisation

Preparation for welding
• The handle (11)
• Ensure the minimum cross-section when using extension cables. The extension cable must be approved for the
site of use (e.g. in the open air) and marked correspondingly. When using a power unit for power supply, it's
nominal power rating is: 2 x nominal power rating of the hand extruder.
Length
[m]
up to 19
20 – 50
Switching on
• Connect the WELDY hand extruder to the mains supply.
• Switch on the tool at the
• Adjust the hot air temperature by the
In order to reach the operating temperature the tool needs to heat up
for at least 10 minutes.
Starting protection
The tool is equipped with current
the drive will switch off automaticaly
minute; press the

Starting the welding process

• Fit the required WELDY
• Welding can begin once the operating temperature has been attained.
Operate the tool drive on/off switch (10)
4 mm diameter into the
Adjust the heat of the tool until it reaches the ideal temperature to start the work.
•
Heating
(position 7)
DANGER!
Never feed welding rod into both welding rod openings at the same time.
Keep the welding rod feed clean and dry.
13
can alternatively be mounted left, right or bottom of the tool.
Minimum cross-section (at ~230V)
[mm
2.5
4.0
hot air blower switch (13).
air temperature potentiometer (12)
overload protection fuse (8). In case of too high current consumption,
if the material in the screw is insufficiently plasticized. Wait for 1
overload protection fuse (8),
welding shoe (1)
welding rod opening (4)
]
2
the tool will re-start again.
according to the paragraph "change of the welding shoe".
for this purpose, operate the tool only when feed welding rod of 3 or
and allow a small amount plasticized material to escape.
Start-up waiting period:
10 minutes
to position 7.
Ready