Charge current
Battery Capacity: charging
Battery Capacity: maintaining
ELECTRICAL PARTS
Delivered with:
• Input: 50cm
• Output: 150cm
• Short cable with alligator: 30cm
• Short cable with ring terminal: 30cm
ENVIRONMENTAL CHARACTERISTICS
• Operating Temperature: 0 to 45° C
• Storage Temperature: -25 to 85°C
• Operating Humidity Range: 0 to 70% RH
• Cooling: Passive / Natural
TECHNICAL SPECIFICATIONS
Part number
Type
Approvals
Input voltage range
Input frequency
Output
Size (LxWxH) in mm
Weight
CHARGING INSTRUCTIONS
STEP 1 - Pre Charge Check & Electrolyte Level Check
• Check the Battery Electrolyte level (Not required on sealed & Main-
tenance Free Batteries).
• If necessary, remove the vent caps and add distilled water so the
levels are halfway between the upper and lower fill lines.
• Check the Voltage Output Switch on the charger and make sure it's
on the correct voltage.
STEP 2 - Connecting the Battery charger to your Battery
• If the Battery is out of the vehicle:
• Connect the Red lead from the charger to the positive (+) battery
terminal.
• Connect the Black lead from the charger to the negative (-) battery
terminal.
FULBAT - www.fulbat.com
0,75A
2-20Ah
2-30Ah
FULLOAD 750
Automatic
CE
100-240V
50/60Hz
0.75A @ 6/12V
80x50x28
0.2Kg
• If the Battery is still in the vehicle, determine if the vehicle is positively
(+) or negatively (-) earthed.
• If Negatively Earthed (Most Common) – FIRST Connect the Red (+)
battery charger lead to the positive (+) Battery post and then connect
the Black (-) battery charger lead to the vehicle's chassis and away
from the fuel line.
• If Positively Earthed – FIRST Connect the Black (-) battery charger lead
to the Negative (-) battery post and then connect the Red (+) battery
charger lead to the Vehicle's chassis and far away from the fuel line.
STEP 3 - Connect the battery charger to Mains Power (240Vac)
• Connect the battery charger to a 240VAC Mains Powered socket.
• Turn on the 240VAC Mains Power.
• The Charger will automatically start when AC power is connected
and switched on. (Note: If the Fault Indicator LED illuminates Red,
please check your connections as it's likely that the Positive and
Negative Leads are reversed. Refer to Trouble Shooting Page for
further information)
STEP 4 - Disconnecting the Battery charger from Battery
• If the Battery is out of the vehicle.
- Switch OFF and Remove the AC Power Socket from the outlet.
- Remove the Black lead and then the Red lead.
- Check electrolyte levels if possible.
(As they may need topping up with distilled water after charging)
• If the Battery is in the vehicle.
- Switch OFF and Remove the AC Power Socket from the outlet.
- Remove the lead from the vehicle chassis.
- Remove the lead from the battery.
3
BLACK
RED
BLACK
RED
RED
BLACK