BaByliss 9000 Mode D'emploi page 9

how to USe YoUR BABYLISS 9000
INStRUCtIoNS FoR USe
• Press and hold the on/off button for 2
seconds the gentle notification sound
indicates that your styleris switched on.
• Once the styler is switched on it will
automatically start heating up to160°C.
• There are 3 temperature settings 160°C,
170°C and 180°C which are indicated
by the LEDs as shown below.
• To select the temperature setting press
the on/off button once, twice or three
times.
• The LEDs will flash when your styler is
heating up and will stop flashing once
the target temperature is reached and it
is ready to use.
• If you have delicate, fine, bleached or
coloured hair, use the lower heat setting.
For thicker hair, use the higher heat set-
ting. We suggest when using for the first
time you test the heat settings to ensure
you've got the correct temperature
for your hair type. Start on the lowest
setting and increase the temperature as
necessary.
• Ensure your hair is dry and combed
through.
• Divide hair into sections.
• Please note: Before styling make sure the
universal heat glove is worn on the hand
handling the hair around the barrel.
• Pressing the lever, place the appliance
midway up a section of hair and spread hair
evenly between the lever and barrel.
• Once hair is in place carefully let go of
the lever so the hair is held securely
between lever and barrel. Gently slide
the appliance down to the hair ends.
• Wind the hair around the barrel at a
slight angle, so the hair wraps around the
barrel in a spiral motion. As you wind the
hair around the barrel, ensure the hair is
distributed evenly so the entire section
is touching the barrel, try not to overlay
the hair
• Hold the end of the hair in place for
5-8 seconds, depending on your hair
type. Then press the lever to release the
section of hair and pull the appliance
away.
• Repeat as necessary.
• Allow hair to cool before combing
through.
• To switch off your styler please press and
hold the on/off button for 2 seconds.
The gentle notification sound indicates
the styler has switched off.
• Allow to cool before storing away.