Technical Specifications - MW TOOLS VP60 Mode D'emploi

M1.2.VP60-VP200.NLFREN - 08022018
EN
• Do not exceed the recommended operating air pressure. This could damage equipment. See specifications.
• Keep a type abc fire extinguisher nearby in case of fires.
• Always protect your skin and eyes from contact with grease.

2 Technical specifications

Model
Duty of trolley
Drum cover diameter of grease tank
Follower plate diameter
Grease outlet pressure
Air pressure
Pump ratio
Hose connection
Hose length
Description:
Power from air compressor which is safe, environmental-friendly and free of spark.
Spare parts: See pages 11-12
3 Operation
3.1 Preparation
1. Put grease tank on the trolley.
2. Put the pump, upper cover with follower plate into the grease tank, slowly in 20~30°gradient.
6. Put the upper cover down in a straight vertical direction.Untill the oil
3. Make sure close connection between grease and rubber plate.
4. Screw on the fastener (both on the follower plate and handle bar) with grease tank in order to fix.
5. Take the upper cover up. Fill the grease into tank. inlet of pump reaching the bottom of tank.
6. Put the upper cover down in a straight vertical direction, until the oil inlet of pump reaching the bottom of tank.
7. Screw the nuts tightly.
7. Screw the nuts tightly.
8. Now it is ready for filling grease.
3.2 Filling grease
8. Now it is ready for filling grease
1. Connect the air inlet with air compressor.
Grease Filling
2. Aim the grease filling gun at the right point.
3. Shooting gradually according to the amount of grease required.
4. Turn off the air compressor, remove the pipe on the machine.
1. Connect the air inlet with air compressor.
5. Clear the grease filling gun, also working area.
1
2. Aim the grease filling gun at the right point.
VP60
20 - 60 kg
385 mm
370 mm
300~400 bar (4350~5800 psi)
6~8 MPa (87~115 psi)
50:1
1/4''
4 m
2
9
VP200
180 - 200 kg
600 mm
585 mm
300~400 bar (4350~5800 psi)
6~8 MPa (87~115 psi)
50:1
1/4''
4 m