Smartpond MFBX500P Mode D'emploi page 9

• The exterior surface of the filter box may also need occasional
cleaning. Particularly if the openings in the top of the filter box
are obstructed. When cleaning the filter box use warm water
only. Do not use any chemicals that may destroy the beneficial
bacteria.
NOTE: The bio-balls in your filter system and the inside surfaces
of the filter box contain the beneficial bacteria. At least once
a year the entire system should be disassembled and cleaned
thoroughly using warm water. This should not be done during
the warm season as it may take up to 8 weeks to re-establish
the environmental balance. The best time of the year to
"breakdown" your system is in early spring before the water
temperatures begin to rise. This is also the ideal time to replace
the filter pads.
• Reassemble all part and place in water before recoonecting to
the power source.
PUMP
Regular cleaning of the pump may be necessary depending
upon the environment which it is operated. Clean the pump
when it is visibly soiled or when a drop in performance is
detected. Clean pump in 4 easy steps!
Step1: Before cleaning,
always disconnect the pump
from the power source and
remove the pump cover.
Step 2: Remove the impeller
cover to expose the impeller
assembly. Remove the
impeller assembly by gently
pulling on the impeller blades.
The impeller is held in place by
a magnet.
Step 3: Use a soft cloth or
brush and warm water to clean
the impeller and the inside of
the impeller housing.
Step 4: Reassemble all pump parts and place in water before
reconnecting to the power source.
TROUBLESHOOTING
IF THE PUMP FAILS TO OPERATE:
• Check to make sure the power cord is plugged in and the pump is
getting power.
• Check the pump outlet and any tubing, fountains, spitters etc. for kinks
or obstructions.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497 7