Preparing The Units - Seenergy Down Draft Piano Manuel

INSTALLATION
The following must be noted
Electrical connection: To be carried out only by a licensed expert. Incorrect connection
will invalidate the warranty.
Installation: To be carried out only by a professional. The fitter is liable for any damage.
Connection type: The appliance fulfils the requirements of protection class I and may
only be operated in conjunction with an earth conductor.
Installation: An all-pole isolating switch with at least a 3 mm contact gap must be
included in the installation.
Support: Refrigerators, dishwashers, non-ventilated ovens and washing machines must
not rest on a support. Modular/compact dishwashers of the same brand can rest on a
support. Work surface thickness must be at least 40 mm.
If an oven is being installed underneath the hob, the work surface thickness may differ
from the dimensions given in these instructions. Observe the information in the oven
installation instructions.
Partition floor: If the underside of the hob can be touched, a partition floor must be
fitted. Ask your specialist retailer for a partition floor as an accessory. If you use your
own partition floor, the minimum distance to the mains connection of the appliance
must be 10 mm.
Work surface: Level, horizontal, stable.
Wearers of electronic implants!
The appliance may contain permanent magnets which may affect electronic implants,
e.g. heart pacemakers or insulin pumps. Therefore, during installation, wearers of
electronic implants must maintain a minimum distance of 10 cm from the appliance.

Preparing the units

Fitting unit: Heat resistant to at least 90°C.
Cut-out: Minimum distance to the side walls: 70 mm. After the cutting out work is
complete, remove the shavings.
Cut surfaces: Seal with heat-resistant material.
Connecting and fitting the hob
Before connecting the appliance, check the household installation.
EN/1