Before Use - Rexel ClassicCut CL100 Manuel D'utilisation

Specifications
Models
Product Code
Sheet Capacity 80g/m
2
Cutting Length
Integrated Paper Guide
Size Guide
Diagonal Lines
1 Guillotine base with calibrated grid
2 Metric and Imperial scale guide
3 Transparent safetyguard
4 Blade / handle assembly
5 Cutting arm safety latch
6 Safety guard/handle retaining bracket
m NOTE: Please retain this information
regarding safe operation of this
paper guillotine
m CAUTION: Guillotine should be operated
by an adult or under adult
supervision
m CAUTION: Sharp blade, do not touch the
edge of the blade
m CAUTION: Always secure the safety guard
to the handle using the retaining
bracket

Before use

m CAUTION: Sharp Blade. Lock blade arm
down with safety latch before
installing handle.
m
CAUTION: Before use ensure raised handle
blade does not fall when handle
is released. Do not attempt to
adjust any parts.
4
Rexel ClassicCut™ CL100 Rexel ClassicCut™ CL120
2101970 2101971
10 10
300mm (12") 457mm (18")
A4, A5, A6 & A7 A3, A4, A5, A6 & A7
Centimetres and Inches Centimetres and Inches
15, 30, 45, 60 degrees 15, 30, 45, 60 degrees
m
m
m
m
1
2
3
CAUTION: Do not lubricate the blade
CAUTION: Always latch the blade/handle in
the down, closed position when
not in use
CAUTION: Do not carry the guillotine by
holding the cutting blade or the
cutting arm
CAUTION: Always operate the guillotine
with the safety guard in place
How to install safety guard
A. Rotate the safety guard retaining bracket on the
handle until it is vertical (1), then secure it using
the supplied screw (2) (CL100 only). Hold the
top of the guillotine with your left hand and push
the handle on to the end of arm until it snaps into
place (3).
B. Screw the safety guard securely into the proper
holes in the base as indicated in the pictures,
ensuring the edge of the safety guard locates
within the retaining bracket (D)
C. Safety guard should now be locked in place
and is ready for you to start.