Control Panel - Wood's WHU600 Guide D'instructions

4.4 Control panel

Start or stop the humidifier.
AUTO-mode.
Set fan speed:
fourth speed for each touch. Touch the fifth time and it enters AUTO
mode. In AUTO-mode, the fan speed will be set depending on your selec-
ted humidity level. Set fan speed is shown as dashes on the right hand
side of the display.
Set desired humidity.
SETTING
between 40% and 75%.Note that the humidifier will operate only when
set humidity level exceeds the ambient humidity level. When the set
humidity level is higher than ambient humidity level the unit will stop and
automatically restart when the humidity drops. Press once, it will increa-
se by 5%RH. After setting expected humidity, LED display blinks for 5
seconds, then switch to show current temperature. If current humidity is
lower than setting humidity, device will work in the third speed. If current
humidity is higher than setting humidity, device will stop humidifying and
stay in sleeping mode. (During sleep mode, ION and HEATING function
are not available to select.) When current humidity is lower than setting
humidity 2%RH, device will exit sleeping mode and humidify in previous
setting. When setting reaches 75%RH, press again and it will change into
AUTO mode and show "CO" on LED display. Press again, it will be back
to 40%RH. (AUTO mode is not available to select under CONSTANT
HUMIDITY function is on.)
Activate the ionizer.
you a better indoor air quality. The ION symbol is visible in the display
ION
when the function is activated. Press again to deactivate
Activate the
mist. By using the heater you will get a faster and more pleasant
humidification effect. The heater symbol is visible in the display when the
function is activated. Note that it may take up to 15 min before the mist is
heated properly. Press again to deactivate the heating function.
Set timer. When the humidifier is operating, press the timer button to
choose time for automatic shut off. Select between 1 to 12 hours. Set
TIMER
time is shown in the display, counting down with every hour passed. After
set time has passed, the humidifier will shut off. Press the TIMER button
repeatedly until it says "- H" to deactivate the timer function.
Low water indication symbol
When this symbol is visible there is not enough water in the water tank.
The humidifier stops. Refill the water tank to restart the humidifier.
English
When turned on, the humidifier will start in
Press repeatedly to choose fan speed. First speed until
Press repeatedly to choose desired humidity
The ionization is an air cleaning feature and will give
heater. When activated, the humidifier will exhasut warm
10