TROUBLESHOOTING
PROBLEM
Burner won't light
Burner flame is low
Carbon build-up
Thick black smoke
POSSIBLE CAUSE
Propane cylinder is empty
Blockage in orifice
Control knob is not in ON position
Gas pressure is low
Outdoor temperature is less than 4.4 ºC/40 ºF
and
tank is less than 1/4 full
Control knob fully ON
Dirt or film on reflector and burner screen
Blockage in burner
Figure 236, Page 21
Project 70016155-70165938
CORRECTIVE ACTION
Replace propane cylinder
Clear blockage
Turn control knob to ON
Turn cylinder valve OFF and fill the
cylinder
Use a full cylinder
Check burner and orifices for
blockage
Clean reflector and burner screen
Remove blockage and clean burner
inside and outside
CSA GROUP