Cardin Elettronica 500 Mode D'emploi page 20

Once you have installed the keypad, enter the service mode to set the keypad's operating parameters.
Attention: before setting up the keyboard you must calibrate the proximity sensor with the installation's ambient
conditions by following the procedure described in menu 13 of the section 'Setting the optional parameters'.
1. Changing the access password
1a Type '# password ' on the keyboard. The default password is 123456 .
1b The keypad will sound one 3-second long beep and the green led "L1" will flash quickly;
(if the password is wrong the red led 'L2' will flash quickly five times)
1c Type '# 01 ' to enter the menu 'modify password'.
1d Type the new password (maximum 6 digits) and confirm with ' '
(for example: 112233 ).
1e The keypad will sound a 3-second long beep
The password has been changed
Wait 20 seconds to exit the service mode
Attention: The password allows access to the code management functions and can be changed as many times
as required according to the needs of the system. The code should be written down and kept in a safe place. If you
lose the password you will have to send the keyboard back to the manufacturer to be reset.
Before memorising codes for the first time remember to cancel the entire memory content.
STARTING UP
20